The DI MOD Pro is a high quality, low noise module that mounts in the Modular Endpanel of your Templeboard. It transforms two unbalanced 1/4" instrument or line level signals into two balanced XLR outputs that can be sent to the front of house or a recording interface. The thru ...The DI MOD Pro is a high quality, low noise module that mounts in the Modular Endpanel of your Templeboard.
It transforms two unbalanced 1/4" instrument or line level signals into two balanced XLR outputs that can be sent to the front of house or a recording interface. The thru jacks (1/4 with red nuts) allow you to send a parallel output to your amplifiers. Features - High current audio op-amps keep your signal ultra-clean even over long cable runs - All Temple MODs install easily with two screws - Ground lift and -15d - B switches accessible on the back of the module - Send parallel 1/4" outputs to your amps alongside the XLR outs Specifications Power Requirements: 42m - A at 9VDC, 48m - A at 18VDC Frequency Response: 20Hz to 50k - Hz +/- 0.1 d - B into 2.5k load Input Impedance: 1.1MΩ Output Impedance: 105Ω Pad Attenuation: -15d - B